COMPANY HEADER
Terms
Request Information
  • Design for power factor correction with high flux density material
  • 20% to 50% smaller than traditional designs
Unit of Measure

Electrical Parameters at 25 ºC

Inductance (±15%)

 N/A 300.0 µH

Maximum Direct Resistance (RDC)

 N/A 0.10 Ohm

Maximum Dimension A

 N/A 35.0 mm

Maximum Dimension B

 N/A 20.0 mm

Nominal Dimension C

 N/A 16.0 mm

Nominal Dimension D

 N/A 31.5 mm

Nominal Dimension E

 N/A 1.00 mm

Specifications

Direct Current (DC) (Idc)

 N/A 5.0 A

Minimum Switching Frequency

 N/A 32 kHz

Maximum Alternating Current (AC) Line Voltage (Vac)

 N/A 265 V

Standard Operating Temperature Range

 N/A -40 to +130 ºC

Available Design

 N/A custom

Note

N/A

  • Inductance test @ 10 kHz, 0.1 Vrms
  • IDC: 10% roll off Typical (20% Maximum) from initial inductance value
  • Add -V for Vertical Mount, -H for Horizontal Mount, -W for Hook Up wire
  • Extended length hook up wire with Fast-On available on request
Dimensions
Unless otherwise specified, all tolerances are:
inch: .XX : ±0.015 .XXX : ±0.004
mm: X.X : ±0.38 X.XX : ±0.10